Redding Reloading Die Spacer Kit (80901) - 3-Piece Case Length Compensation Set for 7/8-14 Dies, No-Crimp Adjustment, Partial Resizing, .44/.44 Mag & .38/.357 Mag Spacers

Redding Die Spacers allow for quick compensation for case length, partial resizing, or to make a no-crimp adjustment without the need to move the locking rings. Kit contains a no-crimp or partial resizing spacer (.062), a 44 Special/44 Magnum spacer (.125) and a 38 Special/357 Magnum spacer (.135). Fits all 7/8" - 14 Dies.

• SPEED & EFFICIENCY - The Redding Reloading Die Spacer Kit speeds up die setup by letting you adjust height instantly without moving lock rings; Swap round types, shift setups, or fine-tune die position in seconds for faster, smoother, repeatable reloading
• CASE-LENGTH PRECISION - These spacers deliver precise compensation for case-length variations, keeping sizing depth consistent across mixed brass; Maintain uniform rounds and protect accuracy with simple, repeatable adjustments that eliminate guesswork
• NO-CRIMP & PARTIAL-RESIZE CONTROL - Switch from crimped to no-crimp loads or set up partial resizing without disturbing your original die settings; The kit gives controlled adjustments for tuning case tension and sizing just the way your load demands
• MULTI-CALIBER VERSATILITY - With spacers for no-crimp/partial resize, .44 Spl/.44 Mag, and .38 Spl/.357 Mag, this kit makes round or cartridge changes clean and predictable; Each ring sets exact die height for cartridges, ensuring consistent performance
• UNIVERSAL COMPATIBILITY - Built for all 7/8-14 threaded dies and combination die sets, these spacers integrate effortlessly into any reloader's bench; They add precision and convenience to any reloading press without extra tools or adjustments